Предмет: История, автор: baisovbahtier09

причина отставания в развитии внутренней торговли в бухарском эмирате

Ответы

Автор ответа: fazylovasabina12

Ответ:

Потеря значения Великого шëлкового пути, начиная с XVI века, постепенно стала отрицательно влиять на экономическую жизнь государств Средней Азии. Уменьшилась возможность активного участия Бухары на мировом рынке. При этом производимая продукция полностью покрывала потребности внутреннего рынка, что способствовало дальнейшему развитию и механизации производств и, как следствие, повышению производительности труда.

Предыдущий вопрос

Следующий вопрос

Похожие вопросы

Предмет: Английский язык, автор: maksim977

перевидите на русский желательно без переводчика An oil well is essentially a mechanical device and like any other mechanical device it is subject to problems and failures which require repairs. Of all the problems that can occur during production, three stand out the most: equipment failure, wellbore problems, and saltwater disposal. These problems can result in a workover operation.
Workover operations are major remedial operations sometimes required to maintain maximum oil producing rates. If, for example, a well begins to produce an excessive amount of salt water, a service rig is moved onto the well, and operations to reduce the saltwater production are begun. It may be first necessary to "kill" the well with some fluid, such as drilling mud, salt water, oil, or possibly a special workover fluid, which has sufficient hydrostatic pressure to counteract the formation pressure when the hole is filled with the fluid. If the salt water is coming from the lower part of the reservoir, it is usual to squeeze-cement the perforation with either a low-pressure or a high-pressure squeeze.
If the high-pressure squeeze-cementing technique is used, a special packer is run on the bottom of the tubing. If the low-pressure cementing method is used, then a packer is not required, since the pressures applied will not exceed the working pressure of the wellhead equipment. After the cement has set, it may be necessary to drill out the cement from inside the casing and reperforate the casing at the desired intervals, since the cement will have sealed off all the old perforations.
If a well is producing with an excessive gas-oil ratio, it may be possible to reduce the gas-oil ratio by the same squeeze-cementing and reperforating technique. The so-called permanent completion permits all workover operations to be conducted with wireline equipment, eliminating the need for workover rigs.

1 год назад

Предмет: Русский язык, автор: dpu