Предмет: Другие предметы, автор: umutbaeva

составьте башкирские слова от слова БАШКОРТОСТАН

Ответы

Автор ответа: vilkovalera1979

стан,тост,кора,корт,стон,скат,бар,бор,тора,кар,трак,кот,сота,сор,роса,каша и др.

umutbaeva: спасибо большое

Предыдущий вопрос

Следующий вопрос

Похожие вопросы

Предмет: География, автор: GORMarmokLegend

поверхневі води на картах України

2 года назад

Предмет: История, автор: usoltsevasofiia

1. Определите основные державы в VI веке. 2. Какие плюсы и минусы имело географическое расположение Византии в VI веке?
3. Каким принципам руководствовалось Византия во внешней политике?
4. Насколько развитие и процветание Византии зависело от роста и падения Восточных государств?

2 года назад

Предмет: Химия, автор: ceredniknazar0

схема рівняння реакції сполучення

2 года назад

Предмет: Математика, автор: saschapopova2008

решите пример срочно. 74115:243 в столбик. прошу

8 лет назад

Предмет: Английский язык, автор: poks57478

Перевести текст. Otis 1920s controller, operational in NYC apartment building.
In the first half of the twentieth century, almost all elevators had no automatic positioning of the floor on which the cab would stop. Some of the older freight elevators were controlled by switches operated by pulling on adjacent ropes. In general most elevators before WWII were manually controlled by elevator operators using a rheostat connected to the motor. This rheostat (see picture) was enclosed within a cylindrical container about the size and shape of a cake. This was mounted upright or sideways on the cab wall and operated via projecting handle, which was able to slide around the top half of the cylinder.
The elevator motor was located at the top of the shaft or beside the bottom of the shaft. Pushing the handle forward would cause the cab to rise; backwards would make it sink. The harder the pressure, the faster the elevator would move. The handle also served as a dead man switch: if the operator let go to of the handle, it would return to its upright position, causing the elevator cab to stop. In time, safety interlocks would ensure that the inner and outer doors were closed before the elevator was allowed to move.
This lever would allow some control over the energy supplied to the motor and so enabled the elevator to be accurately positioned – if the operator was sufficiently skilled. More typically, the operator would have to “jog” the control, moving the cab in small increments until the elevator was reasonably close to the landing point. Then the operator would direct the outgoing and incoming.

8 лет назад