Предмет: Русский язык, автор: zemskova85

словообразовательный разбор слов: тарелка и сосна

Ответы

Автор ответа: serbur88

Как можно делать уроков 9 часов

zemskova85: можно,когда ребенок учится во вторую смену

Автор ответа: россия00000

тарелка - а окончание,тарелки основа,тарелки корень,к суффикс.
сосна -а окончание,сосн-основа,сос корень,н суффикс

Предыдущий вопрос

Следующий вопрос

Похожие вопросы

Предмет: Алгебра, автор: tetanapagor

спростіть вираз і знайдіть його значення: 2х-3(х+у)+4у якщо х= -1,у=1

1 год назад

Предмет: Математика, автор: lmilashka922

В первом мотке 28 м веревки, во втором 30 м, а в третьем на 5 м. веревки меньше, чем в первом и во втором вместе. Сколько веревки в третьем мотке?

1 год назад

Предмет: Математика, автор: nikitafajkin

КАКАЯ ТАБЛИЦА НА ЗАДАЧУ:

двое рабочих изготавливали одинаковые детали .Один обслуживал 8 станков , обрабатывающих по 11 деталей в час каждый , а другой обслуживал 6 станков, обрабатывающих по 15 деталей в час каждый. За сколько часов они изготовят вместе 1602 детали?

1 год назад

Предмет: Английский язык, автор: poks57478

Перевести текст. Otis 1920s controller, operational in NYC apartment building.
In the first half of the twentieth century, almost all elevators had no automatic positioning of the floor on which the cab would stop. Some of the older freight elevators were controlled by switches operated by pulling on adjacent ropes. In general most elevators before WWII were manually controlled by elevator operators using a rheostat connected to the motor. This rheostat (see picture) was enclosed within a cylindrical container about the size and shape of a cake. This was mounted upright or sideways on the cab wall and operated via projecting handle, which was able to slide around the top half of the cylinder.
The elevator motor was located at the top of the shaft or beside the bottom of the shaft. Pushing the handle forward would cause the cab to rise; backwards would make it sink. The harder the pressure, the faster the elevator would move. The handle also served as a dead man switch: if the operator let go to of the handle, it would return to its upright position, causing the elevator cab to stop. In time, safety interlocks would ensure that the inner and outer doors were closed before the elevator was allowed to move.
This lever would allow some control over the energy supplied to the motor and so enabled the elevator to be accurately positioned – if the operator was sufficiently skilled. More typically, the operator would have to “jog” the control, moving the cab in small increments until the elevator was reasonably close to the landing point. Then the operator would direct the outgoing and incoming.

7 лет назад

Предмет: Английский язык, автор: 776657755

Помогите,смотрите на фото

7 лет назад